65 77 680 Removing and installing (replacing) airbag control unit with gateway module
IMPORTANT:
Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DAMAGE (ESD PROTECTION)
.
WARNING:
Note airbag SAFETY INSTRUCTIONS !
Incorrect handling can activate airbag and cause injury.
NOTE:
Comply with notes and instructions on HANDLING OPTICAL FIBERS
.
Necessary preliminary tasks:
- Disconnect BATTERY NEGATIVE LEAD and cover.
- Remove TRIM FOR INSTRUMENT PANEL at bottom right.
Unlock catches (1) in direction of arrow.
Pull airbag control unit with gateway module (2) out of equipment carrier (3) slightly.
Unlock plug connections (4) and disconnect.
Remove airbag control unit with gateway module (2).
Replacement:
Carry out PROGRAMMING/CODING .