13 54 030 Removing And Installing/Sealing Throttle Valve Assembly (N62, N62TU)

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2010 BMW 650i, 2009 BMW 650i, 2008 BMW 750i, 2008 BMW 750Li, and 2008 BMW 650i. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Read out fault memory of DME control unit; if necessary, work through test schedules
Switch off ignition
Remove AIR INTAKE HOSE

Unlock plug (1) and remove.

Release screws.

Remove throttle assembly (2).

Fig 1: Locating Throttle Assembly And Plug

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Replace sealing ring (1) of throttle assembly (2).

Fig 2: Identifying Sealing Assembly And Throttle Assembly

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Now clear the fault memory.