12 61 280 Removing And Installing/Replacing Oil Pressure Switch (N62, N62TU)
WARNING: This page does not describe the selected car, but rather 17 other vehicles, including the 2010 BMW X5, 2010 BMW 650i, 2009 BMW X5, 2009 BMW 650i, and 2008 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks:
- Switch off ignition
- E65/E66 only: Remove intake filter housing
- E53 only: Remove intake hood with air intake hose
WARNING:
Scalding hazard!
Only perform this task on an engine that has cooled down.
Installation location:
Cylinder bank 1 to 4 on cylinder head, front right.
Engine oil may emerge when oil pressure switch is replaced; have a cleaning cloth ready.
Release plug connector (1) and pull off.
Unscrew oil pressure switch (2).
Tightening torque: 12 61 1AZ . See ENGINE - TIGHTENING TORQUES .
Installation:
Check engine oil level, top up engine oil if necessary.