12 14 521 Replacing Crankshaft Pulse Generator (N62, N62TU)
WARNING: This page does not describe the selected car, but rather 17 other vehicles, including the 2010 BMW X5, 2010 BMW 650i, 2009 BMW X5, 2009 BMW 650i, and 2008 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks:
- Read out fault memory of DME control unit; if necessary, work through test schedules
- Switch off ignition
- If necessary, remove underbody protection.
Installation location:
On transmission housing at bottom right.
Unlock plug (1) and remove.
Release screw.
Withdraw pulse generator (2) from transmission housing.
Installation:
Replace sealing ring.
Replace screw.
Installation:
Now clear the fault memory.