65 11 072 Removing and installing/replacing CD changer: Notes
WARNING: This page is about a different car, the 2006 BMW 650i, 2005 BMW 645Ci, and 2004 BMW 645Ci. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Read and comply with notes on protection against electrostatic damage (ESD protection), refer to 61 35 ... NOTES ON ESD PROTECTION (ELECTRO STATIC DISCHARGE)
.
Necessary preliminary tasks:
- Remove luggage compartment floor trim, refer to 51 47 101 REMOVING AND INSTALLING/REPLACING LUGGAGE COMPARTMENT FLOOR TRIM PANEL .
- Disconnect battery negative lead, refer to 12 00 ... INSTRUCTIONS FOR DISCONNECTING AND CONNECTING BATTERY .
NOTE:
Comply with notes and instructions on handling optical waveguides, refer to 61 00 ... NOTES ON HANDLING OPTICAL FIBERS
.
Fold back covers (1) on CD changer (3).
Release screws (2).
Pull back CD changer (3) slightly.
Unlock and disconnect associated plug connection, remove CD changer (3).
Installation:
Tightening torque, refer to 65 11 1AZ in AUDIO, NAVIGATION AND ANTI-THEFT - TIGHTENING .
Observe tightening torque (risk of damage).
Installation:
When pushing CD changer in, lay associated wire harness carefully by hand. For this purpose, in advance:
Remove bottom right trim panel from instrument panel, refer to 51 45 181 REMOVING AND INSTALLING/REPLACING BOTTOM RIGHT TRIM FOR INSTRUMENT PANEL .
Replacement:
Carry out programming/coding, refer to DIAGNOSIS PROGRAMMING/CODING .