Torque Specifications
WARNING: This page is about a different car, the 2005 BMW 645Ci and 2004 BMW 645Ci. However, it is still accessible from the selected car via links, so may be relevant.
TORQUE SPECIFICATIONS
| Application | Ft. Lbs. (N.m) | |
|---|---|---|
| Bearing Unit On Wheel Carrier | 74 (100) | |
| Collar Nut | ||
| M22 Thread | 148 (200) | |
| M27 Thread | 310 (420) | |
| Compression Strut On Body | 33 (45) | |
| Control Arm To Rear Axle Support (Tighten In Normal Position) | 48 (65) | |
| Control Lines To Oscillating Motor | 22 (30) | |
| Control Lines For Oscillating Motor To Valve Block | 26 (35) | |
| Dynamic Drive Pressure Line Circuit To Valve Block | 26 (35) | |
| Hydraulic Line Connecting Nut | 22 (30) | |
| Hydraulic Line Connecting Nut Return | 26 (35) | |
| Integral Link On Front Wheel Carrier | 74 (100) | |
| Rear Axle Carrier To Body | 122 (165) | |
| Return Line To Valve Block | 30 (40) | |
| Shock Absorber To Trailing Arm | 122 (165) | |
| Shock Absorber Piston Rod On Thrust Bearing | 20 (27) | |
| Stabilizer Bar To Rear Axle Support Retaining Bracket | 21 (28) | |
| Stabilizer Link On Anti-Roll Bar/Swinging Arm | ||
| M10 | 48 (65) | |
| M12 | 74 (100) | |
| Support On Body/Rear Axle Carrier | 21 (28) | |
| Swinging Arm Screw Connection | 177 (240) | |
| Swinging Arm To Rear Axle Support | 122 (165) | |
| Traction Strut To Wheel Carrier | 48 (65) | |
| Trailing Arm To Rear Axle Carrier (Tighten In Normal Position) | 49 (67) | |
| Upper Control Arm To Axle Carrier | 74 (100) | |
| Upper Control Arm To Wheel Carrier | 122 (165) | |
| Wheel Lug Bolt | 89 (120) | |
| INCH Lbs. (N.m) | ||
| Control Rod/Jointed Rod To Ride Height Sensor | 71 (8) | |
| Control Rod To Swinging Arm | 71 (8) | |
| Lateral Acceleration Sensor To Body | 71 (8) | |
| Line Holder/Pipe Holder | 71 (8) | |
| Ride Level Sensor To Holder | 44 (5) | |
| Ride Level Sensor To Rear Axle Carrier | 71 (8) | |
| Valve Block To Holder | 71 (8) | |
| Valve Block To Body Holder | 71 (8) | |