Removal & Installation

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2003 BMW M5, 2003 BMW 540i, 2003 BMW 530i, 2003 BMW 525i, and 2002 BMW M5. However, it is still accessible from the selected car via links, so may be relevant.

Raise and support vehicle. Remove rear wheel(s).
Remove rear brake disc. See BRAKE DISC .
Disconnect return springs with brake spring pliers. See Fig 1.
Twist clamping pins with Special Tool (34 4 000) through 90 degrees and disconnect. See Fig 2.
Remove brake shoes.
If necessary, remove or replace expander by pulling part (A) backwards, press out pin (B), and pull out part (C). See Fig 3.
To install, reverse removal procedure. Coat thread of adjusting bushing (1) and screw (2) with grease. Notice installation position of adjusting screws. See Fig 4.
Check return springs and replace if necessary.
Adjust parking brake and check operation. See PARKING BRAKE under ADJUSTMENTS.

Fig 1: Locating Return Springs

Courtesy of BMW OF NORTH AMERICA, INC.

Fig 2: Removing Parking Brake Shoes

Courtesy of BMW OF NORTH AMERICA, INC.

Fig 3: Locating Brake Shoe Expander Components

Courtesy of BMW OF NORTH AMERICA, INC.

Fig 4: Locating Adjusting Screws

Courtesy of BMW OF NORTH AMERICA, INC.