33 33 001 Replacing left or right rear axle carrier compression strut
WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2010 BMW M6, 2010 BMW 650i, 2009 BMW M6, 2009 BMW 650i, and 2008 BMW M6. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Observe safety instructions
for raising the vehicle
Driving without tension and compression struts is not permitted!
Risk of damage!
The rear axle carrier must be supported at the front if both compression struts have to be replaced!
Driving without tension and compression struts is not permitted!
Risk of damage!
The rear axle carrier must be supported at the front if both compression struts have to be replaced!
Necessary preliminary tasks:
- If necessary, remove rear tension strut
- Remove tank cover
- Version with Dynamic Drive: Disconnect pressure lines for oscillating motor of rear axle from tension strut. See 37 13 100 REMOVING AND INSTALLING/REPLACING PRESSURE LINES FOR OSCILLATING MOTOR/FRONT AXLE .
Release screws (2).
Tightening torque 33 32 17AZ , see 32-CONTROL ARMS AND STRUTS .
Release bolt (1) and remove compression strut.
Secure rear axle carrier by inserting bolt (1).
Installation:
Check threads for damage; if necessary, repair with Helicoil thread inserts .
Tightening torque 33 33 3AZ , see 33-AXLE MOUNTING .