51 24 100 Removing and installing/replacing rear lid lock (upper section)

Necessary preliminary tasks:

Release screws (2) and feed out upper section of rear lid lock (3).

Disconnect plug connection (1).

Installation:

Use self-tapping screws when replacing upper section of rear lid lock (3).

Tightening torque: see 5AZ in 51 24 REAR LID LOCKS

Fig 1: Disconnecting Plug Connection

Courtesy of BMW OF NORTH AMERICA, INC.

Remove lock (1).

Lever out actuating rod (2) and remove upper section of rear lid lock (3).

Installation:

Make sure lock (1) is correctly seated.

Fig 2: Removing Upper Section Of Rear Lid Lock

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Perform function check with trunk lid open.