12 42 500 Removing And Installing Or Replacing Battery Positive Lead (Between Alternator, Starter Motor And Jump Start Connection Point) (N62, N62TU)
WARNING: This page does not describe the selected car, but rather 17 other vehicles, including the 2010 BMW X5, 2010 BMW 650i, 2009 BMW X5, 2009 BMW 650i, and 2008 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.
REFERENCE CHART
| Work step | Note: |
|---|---|
| Switch off ignition | |
| Disconnect battery negative lead | Follow instructions for disconnecting and connecting battery |
| Disconnect battery positive lead at jump start connection point | Tightening torque: 12 42 1AZ . See WIRES TO STARTER for specs. |
| Remove INTAKE AIR MANIFOLD | |
| Remove FAN COWL | |
| Detach battery positive lead from alternator | |
| Release expansion tank | |
| Secure engine in installation position with special tool | |
| Release both engine mounts from above | |
| Lower front axle | |
| Remove right exhaust manifold | |
| Remove HEAT SHIELD FROM STARTER MOTOR | |
| Detach battery positive lead from starter motor | Tightening torque: 12 41 4AZ . See STARTER AND MOUNTING PARTS for specs. |
| Remove battery positive lead |