11 31 Camshaft
WARNING: This page is about a different car, the 2006 BMW X5, 2005 BMW X5, and 2004 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.
CAMSHAFT TIGHTENING TORQUE SPECIFICATIONS (6AZ - 14AZ)
| Type | Thread | Tightening specification | Measure | |
|---|---|---|---|---|
| 6AZ Flange to camshaft | M30 | 145 N.m. | ||
| 7AZ Screw plug for chain tensioner | M50 / S50 US /S62 | M22 x 1.5 | 50 N.m. | |
| All / others | M22 x 1.5 | 40 N.m. | ||
| 8AZ Cylinder for chain tensioner plunger | M67 | M22 x 1.5 | 45 N.m. | |
| N40 / N42 / N45 / N46 / N62 / N73 | M22 x 1.5 | 65 N.m. | ||
| M50 / M52 / M52TU / M54 / M56 / S52 / S50 US | M26 x 1.5 | 70 N.m. | ||
| All / others | M26 x 1.5 | 50 N.m. | ||
| 9AZ Bearing flange on engine block | M60 | M6 | 13 N.m. | |
| 10AZ Reversing rail on engine block | M62 / S62 | M6 /M7 | 14 N.m. | |
| 11AZ Screw-in pin on camshaft | All | M7 | 20 N.m. | |
| Nut on screw-in pin | All | M6 | 10 N.m. | |
| 12AZ Bearing pin for sliding and tensioning rails | M41 / M47 / M47TU / M51 / M57 / M57TU | M16 x 1.5 | 20 N.m. | |
| M67 | M16 x 1.5 | 26 N.m. | ||
| 13AZ Signal disk to camshaft | S62 / S54 | M16 x 1.5 | 50 N.m. | |
| 14AZ Sensor gear to camshaft | N62 / N73 | M14 x 1.5 | 30 N.m. |