61 62 060 Removing and installing / replacing rear window wiper motor

WARNING: This page is about a different car, the 2006 BMW X5, 2005 BMW X5, and 2004 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.

Remove panel for rear lid upper section at bottom.

Remove wiper arm for rear wiper.

NOTE: Secure rear window wiper motor against falling out.

Disconnect plug connection (1) and release screws (2).

Remove rear window wiper motor (3).

Installation:

Insert screws (2) and tighten until hand-tight.

Center rear window wiper motor (3) and tighten down screws (2).

Observe tightening torque, 61 62 1AZ.

Fig 1: Securing Rear Window Wiper Motor

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Replace rubber grommet (1).
Note installation position of rubber grommet (1) (marking must be in horizontal position).

Fig 2: Installing Rubber Grommet

Courtesy of BMW OF NORTH AMERICA, INC.