51 24... Removing and installing/replacing bottom left or right lock support for rear lid

WARNING: This page is about a different car, the 2006 BMW X5, 2005 BMW X5, and 2004 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.

Releasing screw connection for rear lid at bottom:

Open rear lid until screw (1) is accessible (risk of injury by spring tension).

Fig 1: Releasing Screw

Courtesy of BMW OF NORTH AMERICA, INC.

With rear lid in this position, release screw (1) and insert in bore of support (2).

CAUTION: If the second support (2) is released for removal of the rear lid, the rear bumper must be protected against damage.

Screw (1) remains in support (2) until installation.

Fig 2: Fitting Spacer

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Fit spacer (3).

NOTE: The work step "Releasing screw connection for rear lid at bottom" ends here.

Removal and installation or replacement only:

Remove panel for roof pillar at rear. Refer to 51 43 252 REMOVING AND INSTALLING/REPLACING PANEL FOR REAR ROOF PILLAR (D-PILLAR), LEFT OR RIGHT .

Release screw on support at top and remove support.