51 13 402 Removing And Installing Handle Strip (On Trunk Lid)

WARNING: This page is about a different car, the 2006 BMW X5, 2005 BMW X5, and 2004 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.

Difference between versions before and after 09/01:

Fig 1: Identifying Handle Strip Versions

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

In version (B), closed expansion nuts and shorter screws (3.5 x 13 mm) must be used.

Release screws (1) and withdraw handle strip (2) somewhat.

Fig 2: Releasing Screws Of Handle Strip

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect plug connection (1) and remove handle strip (2).

Fig 3: Removing Handle Strip

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Seal(s) of handle strip (2) must not be damaged.

Tightening torque, 51 13 4AZ. Refer to BODY EQUIPMENT - TIGHTENING TORQUES .

Perform function check with trunk lid open.