51 22 300 Removing And Installing/Replacing Window Cavity Cover Strip On Rear Door On Left Or Right

WARNING: This page is about a different car, the 2006 BMW X5, 2005 BMW X5, and 2004 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

00 9 324

IMPORTANT: Observe procedure for using special tool 00 9 324. Refer to 51 2. ... REMOVING WINDOW CAVITY COVER STRIP WITH SPECIAL TOOL 00 9 324 AT FRONT OR REAR .

IMPORTANT: If reusing the existing window cavity cover strip (1), make sure it is not bent.

Lever out window cavity cover strip (1) with special tool 00 9 324 (starting at B-pillar).

Fig 1: Levering Out Window Cavity Cover Strip

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Coat window cavity cover strip (1) with water before fitting.

Window cavity cover strip (1) must be flush at front and rear with door edge.

Installation:

Clips (1) must not be damaged.

Fig 2: Identifying Clips

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Retainers (1) of window cavity cover strip (2) must not be damaged.

Fig 3: Identifying Retainers Of Window Cavity Cover Strip

Courtesy of BMW OF NORTH AMERICA, INC.