12 13 511 Replacing ignition coil (N62)

WARNING: This page is about a different car, the 2006 BMW X5, 2005 BMW X5, and 2004 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.

Switch off ignition.

Remove engine cover.

Pull ignition coil covers (1) out of rubber grommets.

Fig 1: Removing Ignition Coil Covers

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock plug fastener (1) of ignition coil.

Fig 2: Disconnecting Plug Fastener Of Ignition Coil

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect plug.

Pull out ignition coil (2).

This procedure is applicable to all ignition coils.

Fig 3: Removing Ignition Coil

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Insert rubber seal on ignition coils (2) between guides.

Fig 4: Inserting Rubber Seal On Ignition Coils

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Interrogate fault memory of DME control unit.
Check stored fault messages.
Rectify faults.
Now clear the fault memory.