11 61 095 Removing and installing/replacing DISA adjustment unit
WARNING: This page is about a different car, the 2006 BMW X5, 2005 BMW X5, and 2004 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.
DISA ADJUSTMENT UNIT REMOVING AND INSTALLING PROCEDURE
| Work step |
|---|
| Switch off ignition. |
| Remove design cover. |
| Remove engine cover. |
| Remove cover for ignition coils on left and right. |
| Remove bulkhead, equipment compartment, center. |
| Unlock plug on throttle and disconnect. |
| Unlock plug on knock sensor on left and right and disconnect. |
| Unlock plug on oil pressure switch and disconnect. |
| Unlock plug on thermostat and disconnect. |
| Unlock plug on water temperature sensor and disconnect. |
| Unlock plug on exhaust solenoid valve on left and right and disconnect. |
| Unlock plug on inlet solenoid valve on left and right and disconnect. |
| Unlock plug on tank venting valve and disconnect. |
| Unlock plug on alternator and disconnect. |
| Unlock plug on injection pipe on left and right and disconnect. |
| Unlock plug on Valvetronic servomotor on left and right and disconnect. |
| Unlock plug on exhaust camshaft sensor on left and right and disconnect. |
| Unlock plug on inlet camshaft sensor on left and right and disconnect. |
| Unlock plug on eccentric shaft sensor on left and right and disconnect. |
| Unlock plug on differential pressure sensor and disconnect. |
| Remove engine wiring harness from guides. |
| Release engine wiring harness screw connection to intake air manifold on left and right. |