11 14 085 Removing and installing top right timing case cover (N62/N62TU)

WARNING: This page is about a different car, the 2006 BMW X5, 2005 BMW X5, and 2004 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.

(Cylinder Bank 1 To 4)

Necessary preliminary tasks:

Remove right cylinder head cover
Remove vacuum pump
Remove both solenoid valves on right side

Remove cable from holder.

Fig 1: Removing Cable From Holder

G03266834

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1 and 2).

Remove timing case cover (3).

Fig 2: Removing Timing Case Cover

G03266835

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Free sealing face (2) on timing case cover (3) of seal debris and clean.

Fig 3: Installing Free Sealing Face On Timing Case Cover Of Seal Debris

G03266836

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Check adapter sleeves (1) for damage and correct installation position; replace if necessary.

Free sealing face (2) of seal debris and clean.

Fig 4: Checking Adapter Sleeves For Damage

G03266837

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Replace gasket (1) and check for correct installation position.

Fig 5: Replacing Gasket

G03266838

Courtesy of BMW OF NORTH AMERICA, INC.