23 21 Transmission Shafts
WARNING: This page is about a different car, the 2010 BMW 650i, 2009 BMW 650i, 2008 BMW 650i, 2007 BMW 650i, and 2006 BMW 650i. However, it is still accessible from the selected car via links, so may be relevant.
TIGHTENING TORQUE SPECIFICATION - TRANSMISSION SHAFTS
| Type | Thread | Tightening specification | Measure | |
|---|---|---|---|---|
| 1AZ Output flange | S5D 200G/S5D 250G/S5D260Z/S5D 310Z/S6S 420G | Collar nut installed with bolt cement Pretension Release Tighten down |
190 Nm 120 Nm |
|
| S5D 280Z/S5D 320Z | Collar nut installed with bolt cement Pretension Release Tighten down |
170 Nm 130 Nm |
||
| S5D 390Z | Collar nut installed with bolt cement Pretension Release Tighten down |
200 Nm 145 Nm |
||
| GS6-37BZ/GS6-17BG | Collar nut installed with bolt cement Pretension Release Tighten down |
170 Nm 120 Nm |
||
| GS6-53DZ | Collar nut installed with bolt cement Pretension Release Tighten down |
200 Nm 140 Nm |
||
| GS7S47BG | Collar nut installed with bolt cement | 200 Nm | ||
| 2AZ Gear to countershaft | 265/Sport | M10 | 60 Nm |