32 41 250 Removing and installing/replacing fluid reservoir for power steering
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2013 BMW 128i, 2012 BMW 128i, 2011 BMW 128i, 2010 BMW 128i, and 2009 BMW 128i. However, it is still accessible from the selected car via links, so may be relevant.
Special tools required:
- 32 1 260
See STEERING AND WHEEL ALIGNMENT - SPECIAL TOOLS .
WARNING:
DANGER OF POISONING
if oil is ingested/absorbed through the skin!
RISK OF INJURY if oil comes into contact with eyes and skin!
RISK OF INJURY if oil comes into contact with eyes and skin!
IMPORTANT:
Adhere to the utmost cleanliness. Do not allow any dirt to enter the hydraulic system.
Close off pipe connections with plugs.
Close off pipe connections with plugs.
Recycling:
Catch and dispose of hydraulic fluid in a suitable container.
Observe country-specific waste-disposal regulations
Necessary preliminary tasks:
- Draw off and dispose of hydraulic fluid from fluid reservoir
Release screw (1).
Tightening torque, see 32 41 1AZ in 32 41 PUMP AND OIL SUPPLY .
NOTE:
If necessary, raise and/or turn fluid reservoir in order to gain better access to hose clamps.
Remove hose clamps if necessary with special tool 32 1 260 .
Disconnect suction line and radiator return line from fluid reservoir.
Lift out fluid reservoir.
After installation:
- Fill and bleed hydraulic system
- Check pipe connections for leaks