51 41 081 Replacing armrest on front left or right door trim panel (long version or from 03/2007)
WARNING: This page is about a different car, the 2010 BMW 550i, 2009 BMW 550i, and 2008 BMW 550i. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks:
- Remove FRONT DOOR TRIM PANEL
Driver's side:
- Remove HANDLE RECESS
Passenger side:
- Remove TOGGLE SWITCH
- Remove DOOR HANDLE
IMPORTANT:
Only drill down to door trim panel area so as not to damage the contact surface.
Armrest is only welded to door trim panel during initial fitting; if necessary, release nuts in place of welding spots.
Armrest is only welded to door trim panel during initial fitting; if necessary, release nuts in place of welding spots.
Drill out welding spots (1) on door trim panel (2) with 8 mm dia. welding spot drill bit.
Remove armrest.
Installation:
Secure armrest with nuts (3).