51 11 050 Removing and installing/replacing carrier for front bumper trim

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 BMW 535xi, 2010 BMW 535i, 2009 BMW 535xi, 2009 BMW 535i, and 2008 BMW 535xi. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove FRONT BUMPER TRIM

Detach wiring harness (1) from impact absorber (2).

If necessary, disconnect plug connections from add-on parts on carrier.

Version with ACC:

If necessary, remove ACC sensor. See REMOVING AND INSTALLING (REPLACING) ACC SENSOR or REMOVING AND INSTALLING/REPLACING LONG RANGE SENSOR (LRR SENSOR) (FROM BUILD DATE 03/2007) .

Fig 1: Detaching Wiring Harness From Impact Absorber

G04760817

Courtesy of BMW OF NORTH AMERICA, INC.

Version with headlight washer system:

If necessary, disconnect line (2) on right from washer fluid reservoir coming from T-distributor (1).

Fig 2: Disconnecting Line On Right From Washer Fluid Reservoir Coming From T-Distributor

G04760818

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Carrier must not be separated from deformation elements.

NOTE: The operation is described on the left side; proceed in the same way for the right side.

Release screw (1).

If necessary, drill out rivets (3).

Release screws (2).

Remove carrier (4) with deformation element towards front.

Installation:

Fig 3: Removing Carrier With Deformation Element Towards Front

G04760819

Courtesy of BMW OF NORTH AMERICA, INC.

If necessary, use screws and locking pins (instead of rivets) to secure deformation element.

Tightening torque 51 11 4AZ .

Replacement:

Remove impact absorber

Depending on version:

Remove both ACCELERATION SENSORS
Remove both HIGH-PRESSURE NOZZLES FOR HEADLIGHT WASHER SYSTEM
Remove night vision camera. See REMOVE AND INSTALLING COMPLETE NIGHT VISION CAMERA (FROM 03/2007) or REMOVE AND INSTALLING COMPLETE NIGHT VISION CAMERA (UP TO 03/2007) .
Remove bracket for ACC sensor
If necessary, remove both near range sensors. See REMOVING AND INSTALLING (REPLACING) LEFT OR RIGHT SHORT RANGE SENSOR (SRR SENSOR) (M TECHNIK AERODYNAMIC KIT) or REMOVING AND INSTALLING/REPLACING SHORT RANGE SENSOR (SRR SENSOR) .