17 11 031 Removing and installing/replacing fan cowl with electric fan
Necessary Preliminary Tasks:
- Read out fault memory of DME control unit
- Switch off ignition
- Remove radiator cover
- Remove front engine underguard
- Unclip coolant hose at bottom from fan cowl
- Unclip vent line at top from fan cowl
Unlock plug (1) on AUC sensor and disconnect.
Unlock plug (2) and remove.
NOTE:
For purposes of clarity, this work step is shown on the fan cowl after it has been removed.
Fold in left retaining tab to fan cowl (1).
Raise fan cowl (1) approx. 3 cm.
Fold in retaining tab (2).
Remove fan cowl (1) towards top.
Installation:
Insert retaining tab (1) at bottom on module carrier.
Convert AUC sensor when replacing fan cowl.
NOTE:
Now clear the fault memory.