51 13 402 Removing and installing handle strip (on trunk lid)

Version from 10/99:

Remove panel for rear lid in rear area. See 51 49 000 Removing and installing / replacing trim panel for trunk lid (touring) 

Feed out wiring harness (2) in direction of arrow from bracket (1).

Disconnect plug connection (3).

Release screws (1) and withdraw handle strip (2) somewhat. Version from 10/99:

Remove strip handle (2).

Installation: 

Tightening torque. Refer to BODY EQUIPMENT - TIGHTENING TORQUES .

Check function.

Version up to 10/99:

Disconnect plug connection (1) and remove handle strip (2).

Installation: 

Tightening torque. Refer to BODY EQUIPMENT - TIGHTENING TORQUES .

Check function.