51 12 080 Removing and installing/replacing finisher strip on bumper trim

Remove detent lugs (1) on one side from below, then unclip rest of finisher strip (2).

Version without Park Distance Control (PDC):

Remove finisher strip (2).

Fig 1: Removing Finisher Strip

Courtesy of BMW OF NORTH AMERICA, INC.

Version with Park Distance Control (PDC):

If necessary, disconnect plug connections (1) from ultrasonic converters (2) and finisher strip (3).

Fig 2: Disconnecting Plug Connections

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement only:

If necessary, remove retainers (1) and ultrasonic converter (2).

Fig 3: Removing Retainers & Ultrasonic Converter

Courtesy of BMW OF NORTH AMERICA, INC.