51 36 070 Removing and installing left or right rear side window (touring): Notes

CAUTION: The "Instructions for window cementing" are an essential part of these repair instructions and must be followed without fail, refer to 51 31... INSTRUCTIONS ON GLUING WINDSCREEN .
Remove inside window cavity trim for side window at rear, refer to REMOVING AND INSTALLING / REPLACING INNER WINDOW CAVITY COVER STRIP FOR REAR LEFT OR RIGHT SIDE WINDOW (TOURING) .

CAUTION: Cover rear side panels with protective covers.
Tape off body on inside around side window with fabric adhesive tape.
In addition, mask area around C-pillar finisher on rear door.

Fig 1: Removing Finisher With Clips

G03124546

Courtesy of BMW OF NORTH AMERICA, INC.

Pull off finisher (1) with clips (2).

Fig 2: Identifying Clips On Finisher

G03124547

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

If necessary, replace faulty clips (1) on finisher (2).

Fig 3: Removing Mounting Of Luggage Compartment Roller Cover

G03124548

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1) and remove mounting (2) for luggage compartment roller cover.

Fig 4: Disconnecting Plug Connection

G03124549

Courtesy of BMW OF NORTH AMERICA, INC.

Left side window:

If necessary, disconnect plug connections (1) and (2).

Secure connector and cable to side window with adhesive tape (danger of damage).

Installation:

Lay cable into opening.

CAUTION: When reusing the side window:
If necessary, tape off all antenna wires on side window with fabric adhesive tape (3) (risk of damage).

Fig 5: Identifying Adhesive Bead Area

G03124550

Courtesy of BMW OF NORTH AMERICA, INC.

Due to different position of adhesive bead:

Adjust starting roller of blade in areas (A) and (B) differently (risk of damage).

A scalpel is used for area (C).

Fig 6: Starting Roller Blade

G03124551

Courtesy of BMW OF NORTH AMERICA, INC.