51 31 200 Removing and installing rear window (touring): Notes

Disconnect plug connection (1).

Fig 1: Disconnecting Plug Connection

Courtesy of BMW OF NORTH AMERICA, INC.

Detach adhesive tapes (1) and expose leads (2).

Fig 2: Detaching Adhesive Tapes & Exposing Leads (1 Of 2)

Courtesy of BMW OF NORTH AMERICA, INC.

Detach adhesive tapes (1) and expose leads (2).

Fig 3: Detaching Adhesive Tapes & Exposing Leads (2 Of 2)

Courtesy of BMW OF NORTH AMERICA, INC.

Feed out rubber grommet (1) on left/right. Release nut (2) on left/right and detach cable (3).

Fig 4: Detaching Cable

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: This work step must be carried out with a second person assisting.

Loosen left/right screws (1).

If spacers are fitted, remove them and make a note of number.

Release screws (1) on left/right and remove rear window (2).

Place rear window (2) on a clean surface.

CAUTION: The rear window (with frame) must not be pulled or lifted by its plugs, wires or foil conductor (risk of damage).

Fig 5: Removing Rear Window

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Replace retainer inserts (1).

Replace rubber mounts (2).

Fig 6: Identifying Retainer Inserts & Rubber Mounts

Courtesy of BMW OF NORTH AMERICA, INC.

Install rear window (1) and fix in place with screws (2).

Adjustment of rear window. .

Fig 7: Installing Rear Window

Courtesy of BMW OF NORTH AMERICA, INC.