51 47 151 Removing and installing / replacing left trunk wheel housing trim (touring)

Release screws (1).

Remove mount (2) for trunk roller cover.

Fig 1: Removing Trunk Roller Cover Mount

Courtesy of BMW OF NORTH AMERICA, INC.

Remove trim (1) from lashing eye at opening.

Fig 2: Removing Trim From Lashing Eye At Opening

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1) and remove lashing eye (2).

Fig 3: Removing Lashing Eye

Courtesy of BMW OF NORTH AMERICA, INC.

Release expansion rivet (2).

Raise on-board socket at cap (1) and pull out towards middle of car.

Fig 4: Removing On Board Socket Cap

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect plug connections (1) and (2) and remove on-board socket (2).

Fig 5: Removing On-Board Socket

Courtesy of BMW OF NORTH AMERICA, INC.

Feed out cable (1).

Lever out mount (2) from stud (3) and remove trunk wheel arch trim (4).

Fig 6: Removing Cable & Trunk Wheel Arch Trim

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement only:

Lever out speaker frame (1).

Release locking washers (2).

Remove mount (3) for on-board socket from trunk wheel arch trim (5).

Do not damage guide (4).

Fig 7: Removing On Board Socket Mount From Trunk Wheel Arch Trim & Speaker Frame

Courtesy of BMW OF NORTH AMERICA, INC.