51 32 420 Removing and installing/replacing finisher on front door window frame, left or right

For removal and installation only, not for adjustment:

Open door window.

Partially detach rubber window seal (1) at rear.

Fig 1: Detaching Rubber Window Seal At Rear

Courtesy of BMW OF NORTH AMERICA, INC.

Loosen screws (1).

Remove finisher (2) and press approx. 3 mm towards rear.

Fig 2: Removing Finisher

Courtesy of BMW OF NORTH AMERICA, INC.

Remove trim (1) towards top.

Fig 3: Removing Trim

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

If necessary, replace faulty plastic nuts (1).

Fig 4: Removing Faulty Plastic Nuts

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Check finisher (1) for damage, replace if necessary.

Fig 5: Identifying Finisher

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

To prevent wind noises.

Check gap with a 0.05 mm feeler gauge.

Slide feeler gauge between B-pillar finishers of front and rear doors.

When the finishers are correctly adjusted, it must be possible to feel a slight suction resistance over the entire length of the finisher.

If the gap is too big, this may result in wind noises.

Fig 6: Sliding Feeler Gauge Between B-Pillar Finishers Of Front & Rear Doors

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

If necessary, release screws (1).

Press finisher (2) towards rear and tighten down screws (1).

If gap is still too big, adjust finisher on window frame of rear door.

Fig 7: Installing Finisher

Courtesy of BMW OF NORTH AMERICA, INC.