61 61 270 Removing and installing complete wiper console

Necessary preliminary tasks: 

• Remove cowl panel cover. See 51 13 115 REMOVING AND INSTALLING/REPLACING COWL PANEL COVER
• Remove heater bulkhead. See 51 71 080 REMOVING AND INSTALLING/REPLACING HEATER BULKHEAD

Unfasten plug connection (1) and disconnect. Unscrew bolt (2).

Installation: 

1. Tightening torque. Refer to GENERAL ELECTRICAL SYSTEM - TIGHTENING TORQUE .
   Fig 1: Disconnecting Plug Connection

   Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

1. Fit rubber grommet (1) of wiper console on pin (2).
   Fig 2: Fitting Rubber Grommet Of Wiper Console On Pin

   Courtesy of BMW OF NORTH AMERICA, INC.

Release nuts and feed out complete wiper console through opening in heater bulkhead.

Installation: 

1. Tightening torque. Refer to GENERAL ELECTRICAL SYSTEM - TIGHTENING TORQUE .
   Fig 3: Locating Wiper Arm Nuts

   Courtesy of BMW OF NORTH AMERICA, INC.