11 12 Cylinder Head with Cover
WARNING: This page is about a different variant/trim than selected.
CYLINDER HEAD WITH COVER TIGHTENING TORQUE SPECIFICATIONS (7AZ - 15AZ)
| Type | Thread | Tightening specification | Measure | |
|---|---|---|---|---|
| 7AZ Cylinder head bolts | M70 / S70 / M73 | M10 | Replace screws Do not wash off coating |
|
| Jointing torque | 30 N.m. | |||
| Torque angle | 60° | |||
| Torque angle | 60° | |||
| 8AZ Cylinder head bolts | M60 / M62 / S62 | M10 | Replace screws Do not wash off coating |
|
| Jointing torque | 30 N.m. | |||
| Torque angle | 80° | |||
| Torque angle | 80° | |||
| N62 / N73 | M10 | Replace screws Do not wash off coating |
||
| Jointing torque | 30 N.m. | |||
| Torque angle | 90° | |||
| Torque angle | 90° | |||
| 11AZ Cylinder head cover | All | M6 | 10 N.m. | |
| All | M7 | 15 N.m. | ||
| M21 | M8 | 15 N.m. | ||
| 12AZ Oil trap to cylinder head cover | M21 | M8 | 17 N.m. | |
| 13AZ Timing case to cylinder head | All | M7 | 15 N.m. | |
| All | M8 | 20 N.m. | ||
| 14AZ Plug for oil channel (microencapsulated) | M47 / M57 | M12 x 1.5 | 20 N.m. | |
| 15AZ Vent plugs to cylinder head (coolant) |
M67 | 2 N.m. |