66 31 006 Removing and installing (replacing) ACC sensor

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2014 BMW X6, 2013 BMW X6, 2012 BMW X6, 2011 BMW X6, and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove FRONT BUMPER TRIM .

NOTE: For a better view, graphic shows rear view with bumper support and ACC sensor removed.

Undo screws in marked area on the rear side of the ACC sensor (1). Tightening torque 66 31 1AZ . Remove ACC sensor (1) from holder (2).

Fig 1: Removing ACC Sensor From Holder

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Secure ACC sensor (2) against falling out.

Unfasten plug connection (1) and disconnect. Remove ACC sensor (2).

Fig 2: Removing ACC Sensor

Courtesy of BMW OF NORTH AMERICA, INC.

After installation: Adjust ACC sensor.

Replacement: Carry out vehicle programming and encoding. Adjust ACC sensor.