27 10 050 Replacing output flange for front axle output (ATC 450)
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2014 BMW X6, 2013 BMW X6, 2012 BMW X6, 2011 BMW X6, and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Do not move vehicle with drive power once propeller shaft has been removed.
Replace output flange only together with a new radial shaft seal.
After completion of work, CHECK OIL LEVEL .
Use only the approved oil in this transfer box. See TRANSFER CASE - OPERATING FLUIDS .
Failure to comply with this requirement will result in serious damage to the transfer box!
Operation is identical to REPLACING RADIAL SHAFT SEAL FOR OUTPUT TO THE FRONT AXLE .