22 32 001 Replacing Rubber Mount For Transmission Mounting

WARNING: This page is about a different car, the 2010 BMW X5, 2009 BMW X5, 2008 BMW X5, and 2007 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.

Special Tools Required:

22 1 016
22 1 017
22 1 101
22 1 102
22 1 103
33 4 465

NOTE: See ENGINE AND GEARBOX SUSPENSION - SPECIAL TOOLS and REAR AXLE - SPECIAL TOOLS .

Necessary preliminary tasks:

Remove crossmember for transmission mount.

Place special tool 22 1 016 on opening (1) and insert screw (2) until hand-tight against housing. Pull out rubber mount with special tools 22 1 101 / 33 4 465 and nut (22 1 017).

NOTE: See ENGINE AND GEARBOX SUSPENSION - SPECIAL TOOLS .

Installation : Arrow on rubber mount must point to arrow on housing. Coat housing bore and rubber mount with Circolight.

Insert special tool 22 1 102 with pins into openings of rubber mount.

Install rubber mount with special tools 22 1 102 / 22 1 103 / 33 4 465 and 22 1 017.

NOTE: See ENGINE AND GEARBOX SUSPENSION - SPECIAL TOOLS .

Fig 1: Pulling Out Rubber Mount With Special Tools

Courtesy of BMW OF NORTH AMERICA, INC.

Fig 2: Arrow On Rubber Mount Must Point To Arrow On Housing

Courtesy of BMW OF NORTH AMERICA, INC.

Fig 3: Insert Special Tool 22 1 102 With Pins Into Openings Of Rubber Mount

Courtesy of BMW OF NORTH AMERICA, INC.

Fig 4: Installing Rubber Mount With Special Tools 22 1 102, 22 1 103, 33 4 465, 22 1 017

Courtesy of BMW OF NORTH AMERICA, INC.