66 20 520 Removing and Installing/Replacing A Front Ultrasonic Transducer (Side)

WARNING: This page is about a different car, the 2010 BMW X5, 2009 BMW X5, 2008 BMW X5, and 2007 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove front bumper trim 51 11 FRONT BUMPER

Disconnect plug connection (1) and remove rubber grommet (2).

Installation:

Make sure rubber grommet (2) is securely seated.

Fig 1: Identifying Rubber Grommet And Plug Connection

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock retaining tabs (1) in direction of arrow and pull ultrasonic transducer (2) out of holder.

Fig 2: Unlocking Retaining Tabs And Ultrasonic Transducer

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Make sure rubber ring (1) is correctly seated on ultrasonic transducer (2).

Fig 3: Identifying Rubber Ring

Courtesy of BMW OF NORTH AMERICA, INC.