65 50 160 Removing And Installing/Replacing Trim For Rear Cabin Monitor Display At Front

WARNING: This page is about a different car, the 2010 BMW X5, 2009 BMW X5, 2008 BMW X5, and 2007 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

00 9 340

Unclip trims (1) on both sides with special tool 00 9 340.

Installation:

Make sure trim (1) is securely seated in rear cabin monitor trim at front.

Fig 1: Identifying Special Tool (00 9 340) On Trims

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Tightening torque. See AUDIO, NAVIGATION AND ANTI-THEFT - TIGHTENING TORQUES - X5 .

Fig 2: Identifying Trims Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Unclip trim (1) with special tool 00 9 340 and remove.

Fig 3: Identifying Special Tool (00 9 340) On Trim

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Carefully remove trim (2) and disconnect plug connection (3).

Installation:

Make sure ribbon cable is securely seated.

Replacement:

Trims may only be replaced in pairs so as to avoid differences in color.

Fig 4: Identifying Plug Connection

Courtesy of BMW OF NORTH AMERICA, INC.