62 30 010 Removing and Installing/Replacing Head - Up Display

WARNING: This page is about a different car, the 2010 BMW X5, 2009 BMW X5, 2008 BMW X5, and 2007 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with notes on protection against electrostatic damage (ESD protection). Refer to 61 35... NOTES ON ESD PROTECTION (ELECTRO STATIC DISCHARGE)

IMPORTANT: Comply with notes and instructions on handling optical waveguides. Refer to61 00... NOTES ON HANDLING OPTICAL FIBERS
Do not scratch head-up display lens!

Necessary preliminary tasks:

Remove instrument panel trim. Refer to 62 30 005 Removing and Installing/Replacing Trim for Head-Up Display

Remove foam seal (1) from head-up display.

Disconnect plug connection (2).

Release screws (3).

Tightening torque 62 30 2AZ. Refer to 62 30 HEAD-UP DISPLAY

Carefully feed out head-up display towards top.

Installation:

Clean head-up display lens.

Fig 1: Identifying Plug Connection And Seal
Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Carry out programming/coding. Refer toCODING & PROGRAMMING