61 67 100 Removing And Installing/Replacing High - Pressure Nozzle Of Headlight Washer System On Left (Or Right)

WARNING: This page is about a different car, the 2010 BMW X5, 2009 BMW X5, 2008 BMW X5, and 2007 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

00 9 340

Necessary preliminary tasks:

Remove front bumper trim . See 51 11 156 REMOVING AND INSTALLING FRONT BUMPER TRIM .

Lever out cover (1) with special tool 00 9 340.

Fig 1: Identifying Cover And Special Tool 00 9 340

Courtesy of BMW OF NORTH AMERICA, INC.

Slowly pull out spray nozzle (1) by cover (2).

Unclip cover (2) and remove.

Allow nozzle (1) to slide back slowly.

Fig 2: Pulling Out Spray Nozzle

Courtesy of BMW OF NORTH AMERICA, INC.

Pull back clasp (1) and disconnect plug connection (2).

Unlock catch (3) in direction of arrow.

Pull out high-pressure nozzle (4) towards rear.

Installation:

Make sure retaining lugs (3) engage correctly.

Fig 3: Unlocking Catch

Courtesy of BMW OF NORTH AMERICA, INC.