61 12 850 Replacing ribbon cable (CAS)
WARNING: This page is about a different car, the 2010 BMW X5, 2009 BMW X5, 2008 BMW X5, and 2007 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Read and comply with notes on handling wiring harnesses and cables.
Necessary preliminary tasks:
- Remove Start/Stop switch .
- Remove trim for pedal assembly. See 51 45 185 REMOVING AND INSTALLING/REPLACING PANEL FOR PEDALS .
Disconnect plug connection (1).
NOTE:
Instrument panel (2) removed for purposes of clarity.
Pull off insulating tape (1) with ribbon cable (3) from instrument panel (2). Installation: Make sure ribbon cable is laid correctly. Secure ribbon cable with new insulating tape to instrument panel (2).