51 71 039 Removing And Installing/Replacing Front Left Or Right Wheel Arch Cover (Rear Section)

WARNING: This page is about a different car, the 2010 BMW X5, 2009 BMW X5, 2008 BMW X5, and 2007 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove front wheel.
Remove trim on front wheel arch . See 51 71 470 REMOVING AND INSTALLING/REPLACING TRIM ON FRONT LEFT OR RIGHT WHEEL ARCH .

NOTE: Work shown on X5 3.0i by way of example, deviations in detail are possible in other models.

Release screws/nuts (1 and 2).

Feed out wheel arch cover (3).

Installation:

Ensure wheel arch cover (3) is correctly seated.

Fig 1: Identifying Wheel Arch Cover

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Make sure all covers in wheel arch are correctly seated in relation to each other:

Rear cover (1) overlaps front cover (2)
Cover (4) overlaps rear cover (1)
Cover (3) overlaps covers (2, 4) and rear cover (1) in area (A)

Left side only:

Rear cover (1) overlaps cover (3) in area (B).

Fig 2: Identifying Cover And Overlaps Cover
Courtesy of BMW OF NORTH AMERICA, INC.