51 49 090 Removing And Installing/Replacing Panel For Rear Lid Lower Section

WARNING: This page is about a different car, the 2010 BMW X5, 2009 BMW X5, 2008 BMW X5, and 2007 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.

Raise trim (1) and disengaged springs (2).

Release screws (3).

IMPORTANT: Risk of damage!
When springs (2) are disengaged, rear lid must not be closed.

Fig 1: Identifying Trim And Springs

Courtesy of BMW OF NORTH AMERICA, INC.

Starting at side, pull panel (1) upwards and release from catches (2).

Fig 2: Identifying Catches

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Catches (1) and guides (2) must not be damaged.

Make sure catches (1) and guides (2) are correctly seated.

Fig 3: Identifying Catches And Guides

Courtesy of BMW OF NORTH AMERICA, INC.