51 47 490 Removing And Installing / Replacing Front Assembly Underside Protection
WARNING: This page is about a different car, the 2010 BMW X5, 2009 BMW X5, 2008 BMW X5, and 2007 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Illustration created using X5 3.0i as an example. There may be differences in detail in the case of other models.
Release screws (1).
Pull forward assembly underside protection (2) under bumper trim (3) and remove.
Installation:
Centre underside protection (2) and tighten down screws (1).