41 11 015 Replacing Engine Carrier With Wheel Arch, Left

Read contents of Body, General  . See 41 0 CONTENTS OF BODY, GENERAL .

The steel-aluminum mixed construction is used on the vehicle.

Observe specific procedure.

Remove or cover those vehicle components in the repair area which are susceptible to heat or dust.

Use only approved spot-welding apparatus  for repairs.

Place vehicle on straightening bench.

Following new body parts are required:

• (1) Wheel arch, front
• (2) Engine carrier
• (3) Support, wheel arch
• (4) Reinforcement, support carrier
  Fig 1: Identifying Reinforcement, Support Carrier

  Courtesy of BMW OF NORTH AMERICA, INC.

Open weld joints in area (1).

Fig 2: Identifying Open Weld Joints Area

Courtesy of BMW OF NORTH AMERICA, INC.

Mark severance cut in accordance with measurement a and cut support carrier.

Measurement a=50 mm before 20 mm dia. bore

Open weld joints in area (1).

Installation: 

Weld in reinforcement plate  at severance cut.

Fig 3: Identifying Open Weld Joints Area

Courtesy of BMW OF NORTH AMERICA, INC.

Open weld joints in area (1).

Fig 4: Identifying Open Weld Joints Area

Courtesy of BMW OF NORTH AMERICA, INC.

Mark severance cut (1) in accordance with measurement a and cut engine carrier.

Measurement a=50 mm before 20 mm dia. bore

Open weld joints in area (2).

Installation: 

Weld in reinforcement plate  at severance cut.

Fig 5: Identifying Open Weld Joints Area

Courtesy of BMW OF NORTH AMERICA, INC.

Open weld joints in area (1).

Fig 6: Identifying Open Weld Joints Area

Courtesy of BMW OF NORTH AMERICA, INC.

Drill out riveted joints in area (2).

Open adhesive joints  in areas (2) and (3).

Installation: 

Use 19 rivets (size 815) in area (1).

Use 4 rivets (size 815) in area (2).

Fig 7: Identifying Open Adhesive Joints Areas

Courtesy of BMW OF NORTH AMERICA, INC.

Preparation of new part: 

Mark engine carrier in accordance with severance cut on vehicle and cut.

Cut weld joints on both sides in areas (2).

Adjust new part to fit with straightening attachment or universal mount.

Fig 8: Identifying Cut Weld Joints On Both Sides Areas

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Adjust wheel arch support (1) to fit in conjunction with wheel arch (2).

Remove wheel arch (2).

Weld new part (1) in areas (3).

Fig 9: Identifying Wheel Arch Support And Wheel Arch

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Weld new parts in area (1).

Fig 10: Identifying Weld Parts Area

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Weld new parts in areas (1).

Fig 11: Identifying Weld Parts Area

Courtesy of BMW OF NORTH AMERICA, INC.