33 17 005 Replacing Rubber Mount For Rear Differential Mounting At Rear

WARNING: This page is about a different car, the 2010 BMW X5, 2009 BMW X5, 2008 BMW X5, and 2007 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

33 3 103
33 3 104
33 5 105
33 5 151
33 5 152
33 5 153
33 5 154
33 5 155
33 5 156

Necessary preliminary tasks:

Remove rear differential . See 33 10 010 REMOVING AND INSTALLING/REPLACING REAR DIFFERENTIAL .

Withdraw rubber mount with special tools 33 5 153 , 33 5 152 , 33 5 151 , 33 3 103 and 33 3 104 .

NOTE: Make sure special tool 33 5 152 contacts rear axle carrier correctly.
Use ratchet ring wrench 33 5 105 .

Fig 1: Identifying Special Tools (33 5 153), (33 5 152), (33 5 151), (33 3 103) And (33 3 104)

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Coat bearing bushing in rear axle carrier and new rubber mount with Circolight (refer to BMW Parts Service).

Align rubber mount by way of elongated hole (1) to vehicle transversal direction.

Fig 2: Identifying Rubber Mount Aligning Elongated Hole

Courtesy of BMW OF NORTH AMERICA, INC.

Insert rubber mount (1) in special tool 33 5 154 .

Draw in rubber mount (1) with special tools 33 5 155 , 33 5 154 , 33 5 156 , 33 3 103 and 33 3 104 as far as it will go.

NOTE: Make sure special tools 33 5 154 and 33 5 156 contact rear axle carrier correctly.
Use ratchet ring wrench 33 5 105 .

Fig 3: Identifying Rubber Mount And Special Tools (33 5 155), (33 5 154) (33 5 156) And (33 3 104)

Courtesy of BMW OF NORTH AMERICA, INC.