22 32 001 Replacing Rubber Mount For Transmission Mounting

WARNING: This page is about a different car, the 2010 BMW X5, 2009 BMW X5, 2008 BMW X5, and 2007 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.

Special Tools Required:

Necessary preliminary tasks:

Remove cross-member. Refer to for transmission mounting 22 32 050 Replacing Cross-Member For Transmission Mounting

Place special tool 22 1 016. Refer to 22 1 010 SET OF TOOLS on opening (1) and insert screw (2) until hand-tight against housing.

Pull out rubber mount with special tools 22 1 101/ 33 4 465. Refer to 22 1 010 SET OF TOOLS and nut (22 1 017)22 1 010 SET OF TOOLS .

Fig 1: Identifying Rubber Mount With Special Tools (22 1 101, 33 4 465)

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Arrow on rubber mount must point to arrow on housing.

Coat housing bore and rubber mount with Circolight, refer to BMW Parts Service.

Fig 2: Identifying Rubber Mount And Housing Bore Center Line

Courtesy of BMW OF NORTH AMERICA, INC.

Insert special tool 22 1 102 with pins into openings of rubber mount. Refer to 22 1 010 SET OF TOOLS

Fig 3: Identifying Special Tool (22 1 102)

Courtesy of BMW OF NORTH AMERICA, INC.

Install rubber mount with special tools 22 1 102/22 1 103/33 4 465 and 22 1 017. Refer to 22 1 010 SET OF TOOLS .

Fig 4: Identifying Rubber Mount With Special Tools (22 1 102, 22 1 103, 33 4 465)

Courtesy of BMW OF NORTH AMERICA, INC.