11 00 050 Removing And Installing Engine (N62/N62TU)
WARNING: This page is about a different car, the 2010 BMW X5, 2009 BMW X5, 2008 BMW X5, and 2007 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.
Special tools required:
- 11 0 000
Necessary preliminary tasks:
- Disconnect negative battery lead. See 12 00... INSTRUCTIONS FOR DISCONNECTING AND CONNECTING BATTERY .
- Both exhaust manifolds remain on engine during removal.
Observe specified tightening torque and safety precautions in all work steps.
REFERENCE CHART
| Work step | Note |
|---|---|
| Lift engine hood into assembly position Secure engine in installation position with special tool Remove gearbox |
After removing transmission, secure engine against tilting. |
| Remove intake filter housing . See 13 71 000 REMOVING AND INSTALLING/REPLACING INTAKE FILTER HOUSING (N52K) . | |
| Remove radiator | |
| Remove radiator lines. | |
| Remove expansion tank. | |
| Remove intake air manifold . See 11 61 050 REMOVING AND INSTALLING INTAKE AIR MANIFOLD (N62) . | |
| Remove heater radiator line. | |
| Unlock engine wiring harness section on control unit and detach . | Wiring harness remains on engine. |
| Unlock spark plug wiring harness section on control unit and detach . Wiring harness remains on engine. | |
| Release negative lead on spring strut dome. | |
| Release battery positive lead at positive terminal. | |
| Detach vacuum line and vacuum hose from vacuum pump. | |
| Unlock line on tank venting valve and disconnect. | |
| Remove both oxygen monitor sensors . | |
| Remove both oxygen control sensors | |
| Release negative lead on engine support arm. | |
| Remove vibration damper and tensioning pulley from A/C compressor drive belt | |
| Release power steering pump on bracket, hydraulic lines remain connected. | Do not remove power steering pump, secure against falling down. |
| Release A/C compressor on bracket, lines remain connected, do not evacuate A/C system. | Do not remove A/C compressor, secure against falling down. |
| Release ABS control unit on bracket, lines remain connected. | Do not remove ABS control unit, secure against falling down. |
| Remove lower universal joint of steering spindle |
Vehicles with Dynamic Drive only:
Unlock and detach hydraulic line (1).
Suspend engine off-center from special tool 11 0 000 .
Release engine mounts on left and right from above.
Protect assembly compartment and hydraulic lines against damage.
Installation:
Observe specified tightening torque and safety precautions in all work steps.