54 13 105 Removing and installing/replacing rear drip molding

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2010 BMW X3, 2009 BMW X3, 2008 BMW X3, 2007 BMW X3, and 2006 BMW X3. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove glass slide/tilt sunroof54 13 080 Removing and installing complete glass slide/tilt sunroof .
Remove glass slide/tilt sunroof lid at rear54 10 175 Removing and installing rear glass slide/tilt sunroof cover .

Unlock tab (2) and remove drip molding (1) towards top.

NOTE: 2 springs are loosely connected to guide for drip molding.

Installation:

Make sure springs are reinstalled on drip molding carriers.

Fig 1: Drip Molding

Courtesy of BMW OF NORTH AMERICA, INC.

Removing drip molding carrier:

NOTE: Drip molding carrier cannot be removed without incurring damage.

Break out tabs with a screwdriver and lever out carrier.

Installation:

Replace drip molding carrier and hook into place.

Fig 2: [ Tabs]

Courtesy of BMW OF NORTH AMERICA, INC.