33 17 004 Replacing all rubber mounts for differential mounting at front

WARNING: This page is about a different car, the 2010 BMW X3, 2009 BMW X3, 2008 BMW X3, and 2007 BMW X3. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

33 3 314 33 3 310 REMOVAL/INSTALLATION TOOL KIT
33 3 315 33 3 310 REMOVAL/INSTALLATION TOOL KIT
33 3 361 33 3 360 SET OF TOOLS
33 3 362 33 3 360 SET OF TOOLS
33 4 173 33 4 170 REMOVAL/INSTALLATION THRUST PIECES

Necessary preliminary tasks:

Remove rear differential, see 33 10 010 Removing and installing/replacing rear differential .

Pull out rubber mount with special tools 33 3 314 , 33 3 315 , 33 3 361 , 33 3 362 and a standard nut (1) from rear axle carrier.

Fig 1: Special Tool (33 3 361), (33 3 315) And (33 3 314)

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Observe installation position of rubber mount.
Fig. A = Protrusion (A) in direction of travel, rear
Fig. B = Openings (1) in transverse vehicle direction

Coat new rubber mount and bearing bush with Circo Light.

Fig 2: Direction Of Travel And Transverse Vehicle Direction

Courtesy of BMW OF NORTH AMERICA, INC.

Draw in rubber mount (1) with special tools 33 3 314 , 33 3 315 , 33 3 362 and 33 4 173 as far as it will go into rear axle carrier.

Fig 3: Special Tool (33 4 173), (33 3 315) And (33 3 362)

Courtesy of BMW OF NORTH AMERICA, INC.