31 35 021 Replacing rubber mounts of stabilizer retaining fixture on front axle subframe
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2010 BMW X3, 2009 BMW X3, 2008 BMW X3, 2007 BMW X3, and 2006 BMW X3. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks:
- Remove front underbody protection, see 51 47 490 REMOVING AND INSTALLING / REPLACING FRONT UNDERBODY PROTECTION .
- If necessary, remove steering gear cover on both sides
Release screws (1) and remove stabilizer bar forward from front axle subframe.
Remove retaining bracket (2) and rubber mount (3) on both sides.
Installation:
Keep retaining bracket (2), rubber mount (3) and stabilizer clean and free from oil and grease.
Tightening torque: 31 35 1AZ, see 31 35 STABILIZER BAR .