41 61 000 Removing And Installing Hood/Bonnet

WARNING: This page is about a different car, the 2013 BMW X5 M, 2012 BMW X5 M, 2011 BMW X5 M, and 2010 BMW X5 M. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: Danger of injury!
Support engine hood in fully opened position with suitable apparatus.

IMPORTANT: Removal of the hood/bonnet must be carried out with the assistance of a second person.

NOTE: Carry over schematic representation to the relevant vehicle type.

Release nuts (1).

Tightening torque 41 61 1AZ .

Remove hood lid.

Installation:

Install engine hood at screw locations to on hinge. This dispenses with the need for adjustment after installation.

Fig 1: Identifying Left And Right Hinge Nuts

Courtesy of BMW OF NORTH AMERICA, INC.

If this is not possible, adjust ENGINE HOOD .